Depending on the length of downrod you use, you may need to cut the lead wires back to simplify the wiring. Slide the downrod (A) into the yoke of the motor assembly (G), align the holes, then re-install the downrod clip (C) and downrod pin (B). Feed the wires from the motor assembly (G) through the downrod (A).ģ. Insert the downrod (A) through the canopy (E) and yoke cover (O). Then, partially loosen the set screws (Q) in the yoke at the top of the motor assembly (G).Ģ. ![]() Remove the downrod pin (B) and downrod clip (C) from the downrod (A). Discard the orange packing material from the top and bottom of the motor assembly (G) but save the three fitter plate screws (I) for later.ġ. Remove the three fitter plate screws (I) and the packing material from the motor assembly (G). Important: If using the angle mount, ensure the open end of the mounting bracket (D) is installed facing the floor.Ħ. Attach mounting bracket (D) to outlet box (not included) using screws and washers provided with the outlet box.ĬAUTION: It is very important to use the proper hardware when installing the mounting bracket (D) as this will support the fan. Note: If using this item on an angled ceiling, snap out the perforated section of the canopy cover (F).ĥ. Set aside for later use.ĭetach mounting bracket (D) from canopy (E). Loosen all four preassembled mounting bracket screws (R), then completely remove the two mounting bracket screws (R) from the round holes of canopy (E). Also check the downrod (A) length to ensure the blades (P) will be at least 7 ft. Ensure the blades (P) will be at least 30 in. If using the angle mount, check to ensure the ceiling angle is not steeper than 45°.Ĭlosemount-style mounting is not available for this item.įlushmount installation is not available for this item.ģ. A longer downrod is sometimes necessary to ensure proper blade clearance. For taller ceilings you may want to use a longer downrod (not included).Īngle-style mounting is best suited for angled or vaulted ceilings. Standard mounting is best suited for ceilings 9 ft. ![]() Turn off the circuit breakers and the wall switch to the fan supply line leads. Helpful Tools (not included): AC Tester Light, Tape Measure and Wiring Handbook INITIAL INSTALLATIONġ. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Step Ladder, Wire Cutters and Wire Strippers If any part is missing or damaged, do not attempt to assemble the product. Compare all parts with the package contents list and hardware contents list.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |